                                                                      
                                                                      
HP OMNIBOOK 5700CT NOTEBOOK PC - OS/2 WARP OR WARP CONNECT, INSTALLING
SCSI DRIVERS


INTRODUCTION
  
  When using the HP OmniBook Notebook PC with a docking system, use
  the following instructions to install SCSI support.  This procedure
  is not necessary if OS/2 was installed from a SCSI CD-ROM drive,
  because the SCSI drivers are already installed.
  

REQUIREMENTS
  
  *    HP OmniBook 5700 Notebook PC with OS/2 Warp or Warp Connect
       installed. 
  
  *    HP OmniBook 5700 SCSI drivers.  To create a "SCSI Drivers"
       floppy disk, copy C:\OMNIBOOK\DRIVERS\OS2\SCSI\*.* to A:.  (To
       install correctly, the drivers must be in the root directory 
       of the floppy disk.)  Or get the drivers from the HP OmniBook
       5700 Recovery CD in the \OMNIBOOK\DRIVERS\OS2\SCSI subdirectory. 

PROCEDURE
  
  1.   Insert the floppy disk with the SCSI drivers in drive A.
  
  2.   Open the OS/2 System folder, select the System Setup icon, and
       double-click Device Driver Install.
  
  3.   When prompted, type the path to the HP OmniBook Notebook PC
       SCSI drivers (such as A:\) and choose OK.
  
  4.   Select "AMD SCSI" and click OK.
  
  5.   Remove the floppy disk, then shut down OS/2 and reboot.

______________________________________________________________________
                  Copyright  Hewlett-Packard Co. 1997
       This information is subject to change without notice and
                 is provided "as is" with no warranty.
          Hewlett-Packard shall not be liable for any direct,
        indirect, special, incidental or consequential damages
             in connection with the use of this material.
