=====================================================================
Installing the NEW Creative Labs CD-ROM Driver in OS/2 2.1
SBCD2.ADD Version 1.23
=====================================================================
You should replace any earlier version with this new driver.

INSTALLING SBCD2.ADD to an existing OS/2 system

1.  Check that you have the following lines in your CONFIG.SYS.  If 
    these lines are missing, add them to your CONFIG.SYS and make 
    sure that they are located in your OS/2 directory.  If these 
    files are not in your OS/2 directory then you must follow the 
    Selective Install procedure detailed in your OS/2 manual, you 
    must check the CD-ROM Drive box and select OTHER for the type of 
    CD-ROM Drive attached to your system.

  BASEDEV=SBCD2.ADD /P:XXX (Where 'XXX' is the Address of the SB card)
  IFS=C:\OS2\CDFS.IFS               (The "/T:2" should be added to the
  DEVICE=C:\OS2\OS2CDROM.DMD         SBCD2.ADD line if the customer
  DEVICE=C:\OS2\MDOS\VCDROM.SYS      is using the 1810 interface!)
	
*NOTE: A. These lines should be kept together in the CONFIG.SYS and
	  they MUST be in the order shown above!

       B. Make sure that you do NOT have any duplicates of these lines
	  in your CONFIG.SYS or you will get an error every time OS/2 
	  starts.

2.  Copy the SBCD2.ADD file to the C:\OS2 directory.  In some cases 
    this file may need to be located in the root directory of the C: 
    drive. If you have SBCD2.ADD in the OS/2 directory and OS/2 still 
    will not recognize your CD-ROM Drive then copy the file to the 
    root directory.  This should solve the problem.

INSTALLING OS/2 2.1 (Final release) From CD-ROM using SBCD2.ADD

1.  Make backup copies of the two disks that come with the OS/2 2.1 
    CD-ROM.  Store the original disks in a safe place in case they 
    are needed in the future.

2.  Copy the SBCD2.ADD file to the new disk labeled "Diskette 1".

3.  Next, add the following line to the file CONFIG.SYS found on the 
    new disk labeled "Diskette 1".  This line should come right before
    the line "IFS=C:\OS2\CDFS.IFS /Q".

      BASEDEV=SBCD2.ADD /P:xxx (Where 'xxx' is the I/O 
				Address of the SB card)

4.  Reboot the system with the new disk labeled "Installation 
    Diskette" and follow the installation process accordingly.

5.  After the installation is completed and your system has rebooted, 
    you must copy the files CDFS.IFS and OS2CDROM.DMD from the OS/2 
    installation disk labeled "Diskette 1" into the OS2 directory on 
    your hard drive, then  add the following two lines to your 
    CONFIG.SYS file that is located on the C: drive.  So that you will 
    be able to access the CD-ROM drive after the installation process 
    has completed.

       IFS=C:\OS2\CDFS.IFS /Q
       DEVICE=C:\OS2\OS2CDROM.DMD

6.  Remember to reboot the system.
