New Media Graphics - Video Capture Driver Notes
Version 1.2 
1/25/93

This disk includes a Video Capture driver that works with the Microsoft 
Video for Windows software.  It replaces the driver on the Video for 
Windows DRIVERS diskette.

Use the Control Panel Drivers applet to install the Super Video Windows 
Video Capture driver included on this disk.  Select Add - "Unlisted or 
Updated driver" to install the correct driver.  There is one driver,
compatible with all versions of Super VideoWindows and TV-VideoWindows.

Once the driver is installed, you may use the Video for Windows capture 
program "VIPCAP" to capture frames, sequences of frames, or capture video 
in real time.  

If you have an older SVW-ISA card, you may not be able to use the real
time video capture feature of the VidCap program.  See below.

If you have any problems or questions about the SVW capture driver, 
please call our technical support department at (508) 663-0666 ext. 180.

NEW FEATURES:
=============
- Support for Super Video Windows for IBM Micro channel.
- S-Video input format support on SVW-ISA and -MC boards with S-Video option.
- Sharpness adjustment for digitizing video (in Video Source dialog).
- Audio volume control (in Video Display dialog).

All cards:
==========

   In order to use the Video for Windows Video Sequence capture feature, 
you must enable the interrupt jumper on the board.  The number and location 
of the jumper varies from board to board.  Refer to the board specific 
directions below.  Use an unused jumper block from the I/O address 
selection jumper to enable the interrupt.  If you do not connect the 
jumper correctly, you will get an error only after starting to capture 
a video sequence.  If there is a conflict with the interrupt number used, 
you system may not work correctly or fail to capture video sequences 
correctly.

SVW-ISA, SVW-CM
===============

The interrupt jumper is labeled JP18, and is located above and to the 
left of the edge fingers on the bottom of the card, when looking at the 
top of the board.  These boards use interrupt number 10, and the interrupt 
in the driver setup dialog must be set to 10.

NOTE: Some older revisions of the Super Video Windows board may not 
support interrupts.  These boards are marked REV 2A, REV 2B, or REV 2E.  
They can capture single frames, but can not capture a sequence of frames
in real time.

SVW-SL, TV-Video Windows
========================

The interrupt jumper is labeled JP13, and is located above the shorter 
row of the card edge fingers when looking at the top of the board.
These boards use interrupt number 10, and the interrupt in the driver setup
dialog must be set to 10.

SVW-MC
======

This board for the Micro Channel bus interface does not have a jumper.  
You must run the Configuration program on the reference disk to select
one of the two interrupts - 12 or 15.  The setting in the driver setup
dialog must match the interrupt you select.

===========================================================================

New Media Graphics
780 Boston Road
Billerica, MA  01821-5925

Phone:       (508) 663-0666
Toll Free:   (800) 288-2207
FAX:         (508) 663-6678
CompuServe:  GO MULTIVEN, section 17
