
	6 2 5  S E R I E S   C D - R O M   D E V I C E   D R I V E R

---------------------------------------------------------------------------

	To install 625 series CD-ROM device driver, the syntax in
     CONFIG.SYS is as follows:

     DEVICE=VIDE-CDD.SYS /D:MSCD001 [/P:xxx,yy]

     where [/P:xxx,yy]
	  specifies the IDE port which is connected to the drive and the
	  interrupt request.

	  'xxx' is the base address (hexadecimal notation) of IDE port.
		xxx = 1f0 : Port 1
		      170 : Port 2
		      1e8 : Port 3
		      168 : Port 4

	  'yy' is the interrupt number (decimal notation) of the
	  corresponding IDE port.

     For example,  when eight drives are installed, the command
     line in the CONFIG.SYS file could be entered as follows:

     DEVICE=VIDE-CDD.SYS /D:MSCD001 /P:1f0,14 /P:170,15 /P:1e8,12 /P:168,10

     NOTE:

	Our device driver will automatically search the drives for 4 ports
     up to 8 drives, and the ports are 0x1f0, 0x170, 0x1e8 and 0x168 with
     interrupt number 14, 15, 12 and 10 as default, respectively. If your
     IDE ports and their respective interrupt numbers are the same as
     those mentioned above, you don't have to specify them verbosely.

---------------------------------------------------------------------------

	To enable the CD-ROM drive to read CD-ROM discs that use the High
     Sierra or ISO 9660 format, in addition to installing the 625 CD-ROM
     device driver, you need to insert the following line into your
     AUTOEXEC.BAT file:

     MSCDEX /D:MSCD001

	To have a detail knowledge about the use of the MSCDEX.EXE program,
     please refer to MS-DOS user manual.

---------------------------------------------------------------------------


